Car aircon repair & servicing
Aircon not cold, smelly, or warm again after a gas top-up? We find the cause before adding gas, then repair and service it.
Car aircon not cold, or warm again a few weeks after a gas top-up? Refrigerant is not used up: if it is low, it has leaked. Squad finds the cause first, then repairs and services R134a systems, including leak detection and bidirectional flushing. R1234yf service is not currently available, but the capability is in the pipeline.
When this service may help
- The aircon is not cold enough
- Cooling changes while idling or driving
- Musty or unpleasant vent smell
- The gas needs topping up again and again
- A noisy compressor, or a leaking cooling coil or condenser
How we approach the work
Confirm the complaint
Measure cabin vent temperature and note when cooling performance changes.
Read the system
Compare high- and low-pressure readings, inspect for visible leaks and assess fan operation.
Look deeper
Use a borescope for the evaporator and an electronic refrigerant detector when a leak cannot be confirmed visually.
Service and verify
Use the appropriate pre- and post-repair flush process, then recheck temperatures, pressures and cooling behaviour.
What matters
- Cooling-performance diagnosis
- Pre- and post-repair bidirectional flushing
- Electronic refrigerant leak detection
- Odour and airflow investigation
- Leak and component assessment
Vehicle platforms
- European
- Japanese
- Performance
- Exotic
- All makes
Questions owners ask
How often does Squad recommend an air-con service?
Squad recommends checking and servicing the air-conditioning once every 12 months in Singapore. This is a workshop recommendation rather than a model-specific interval; the exact work still depends on system condition and test results.
What does bi-directional service and flush mean?
Squad’s equipment alternates between higher and lower pressure while directing refrigerant through the system in both directions. Reversing the flow helps flush the circuit more thoroughly than one-direction circulation alone.
Why does Squad usually flush before and after an air-con repair?
The pre-repair flush helps remove old oil and mobile contamination before the replacement component is fitted. The post-repair process helps clear and verify the serviced circuit before final performance checks. This reduces the chance of residue circulating into a new compressor or control component. Heavy metal contamination and nonflushable components may still require replacement rather than flushing alone.
How long does Squad run its flush process?
Squad normally runs the bidirectional flush for 30 minutes. The duration allows repeated pressure and reverse-flow cycles to move oil and mobile contamination through the service equipment. Time alone is not a guarantee: debris level and nonflushable component design still determine whether parts must be replaced.
Can Squad find a leak that is not visible?
Yes. If visual and borescope inspection cannot reveal the leak, Squad can use an electronic refrigerant detector to sense escaping gas around the circuit and HVAC assembly. Very small or intermittent leaks can still require staged testing.
Does Squad service R1234yf systems?
Not yet. Squad currently handles diagnosis, servicing and repair for R134a air-conditioning systems. R1234yf capability is in the pipeline and will be announced only when the equipment and process are ready.
Why does topping up refrigerant only help temporarily?
If refrigerant is escaping, a top-up does not repair the leak. Diagnosis should establish why performance dropped before repeated refilling becomes the routine.
Can a smelly air-con be cleaned?
Often, but the source matters. Filters, evaporator contamination, trapped moisture or drainage issues can produce similar symptoms and may need different work.
What should I send before booking?
Share the model, year, when the cooling becomes weak, whether the fan strength changes and any recent air-con repairs or top-ups.
